Application installation of light strip

2021-10-19

①The four-line lamp has a width of about 22mm, a thickness of about 8mm, and a weight of about 0.25kg/m (4 meters per kilogram).

②The four-wire light strip has four wires, three rows of lights (note that it is not four rows of lights~~), each row of 1 meter 24 lights, 24*3=72. Because the power of each lamp bead is 0.05W, the power of the 72 bead strip is: 72*0.05=3.6W.

③There is a "scissors" mark for every meter, and it can only be cut when the mark is cut. Wrong cutting or cutting will cause a meter not to shine! Some will be off the mark when marking, it is best to carefully look at the mark before cutting Position, just cut the place where there is no connection in the middle. You can tell if you look closely.

④Each light strip must be equipped with a special plug (plug with transformer); when connecting, the transparent plastic cover must be removed, and the test light must be connected before closing. Do not connect directly with a cover, as it is easy to short-circuit.

⑤When installing the light strip, it is usually placed in the light trough and just straightened, or it can be fixed with a string or thin iron wire. For exterior or vertical installation, you need to purchase additional clips and tail plugs. The original clip is completely transparent, it is best to put waterproof glass glue on the tail plug and plug after installation, so that the waterproof performance is better.
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies. Privacy Policy